Table of Contents
Advertisement
In the event of a malfunction, fi rst check all the cable connections and operating states:
1. Receiver and TV set power plugs are connected to wall socket
2. Antenna cables are connected to the receiver input
3. Receiver and TV set correctly connected with a HDMI or Scart cable
4. Audio connections are made to the Hi-Fi or Dolby Digital system as appropriate
5. Receiver and TV set (Hi-Fi/Dolby Digital system) are switched on (check power indicators)
6. Receiver is responding to remote control
A selection of troubleshooting tips is offered below.
Problem
A "No signal!" warn-
ing appears on some
or all channels
The receiver no
longer reacts to the
remote control
Wrong time being
displayed
The following chan-
nels cut out or "No or
poor signal!" appears:
Sport 1, Tele 5, HSE 24
and Sonnenklar TV
Black or blue screen,
no on-screen displays
Network problem
Troubleshooting
Cause
The batteries being used may be
empty or have been inserted into the
battery compartment incorrectly.
Receiver or remote control command
set may have been unintentionally
changed
"Summertime" setting is wrong. An
incorrect time was imported from the
reception signal.
DECT telephones operate on the
same frequency as these channels.
Interference may occur due to an
inadequate level or poor shielding of
cable
Scart connection to TV deactivated
by accidentally pressing the 0 button
Check that the (cross-over) network
cable is correctly connected (clicked
home) at the PC and receiver.
Remedy
Consult an antenna specialist to
have it checked and repaired as
necessary. Check the settings made
in the "Settings", "Antenna & Satel-
lite", "Tuner Confi guration" menu and
modify them if necessary.
Check the batteries (see also "Insert-
ing batteries in the remote control" in
operating instructions part 1)
Set infrared code 1 as described
in the operating instructions under
"Main menu settings", "Basic set-
tings", "Setting the remote control
code"
On "Settings" - "Date and Time" menu
check "Summer Time Enabled" and
change as necessary. Use the power
switch to switch the receiver off from
the current channel, e.g. "Das Erste"
or "ZDF", wait 10 seconds and then
switch it back on
Consult your antenna specialist
Keep pressing the 0 button until the
TV picture reappears on the screen
Refer to your PC or network specialist
139
Advertisement
Table of Contents
