Troubleshooting - Kathrein UFS 80si Operating Manual

In the event of a malfunction, fi rst check all the cable connections and operating states:
1. Receiver and TV set power plugs are connected to wall socket
2. Antenna cables are connected to the receiver input
3. Receiver and TV set are correctly connected to each other by a HDMI or Scart or cinch cable
4. Audio connections are made to the Hi-Fi or Dolby Digital system as appropriate
5. Receiver and TV set (Hi-Fi/Dolby Digital system) are switched on (check power indicators)
6. Receiver is responding to remote control
A selection of troubleshooting tips is offered below.
Problem
A "No signal!" warning appears
on some or all channels
Remote control
responds
Wrong time is displayed
The following channels cut out,
or "No or bad signal!" appears:
DSF, Tele 5, HSE 24 and
Sonnenklar TV

Troubleshooting

Batteries may be discharged
no longer
Remote control code has been
changed inadvertently
The "Summer Time" setting is
wrong. An incorrect time was
imported
signal
DECT telephones operate on
the same frequency as these
channels.
occur due to inadequate output
level or poor shielding of cable
Cause
from the reception
Interference may
Remedy
Consult an antenna specialist to
have it checked and repaired as
necessary. Check the settings
made in the "Settings", "Antenna
& Satellite", "Tuner Confi guration"
menu, and change
necessary.
Check the batteries
By simultaneously pressing the
Back button in conjunction with
buttons on the number pad (1-8)
the remote control code can be
changed. Your receiver requires
the remote control code "1". For
this purpose simultaneously
press the "Back" and "1" buttons.
Check summer time
"Settings" "Time Setup" menu
and change it as necessary
Use the power switch to switch
the receiver off from the current
channel, e.g. Das Erste or ZDF,
wait 10 seconds and then switch
it back on
Consult your antenna specialist
them if
in the
75