Table of Contents
Advertisement
In the event of a malfunction, fi rst check all the cable connections and operating states:
1. Receiver and TV set power plugs are connected to wall socket
2. Antenna cables are connected to the receiver input
3. Receiver and TV set are correctly connected to each other by a HDMI or Scart or cinch cable
4. Audio connections are made to the Hi-Fi or Dolby Digital system as appropriate
5. Receiver and TV set (Hi-Fi/Dolby Digital system) are switched on (check power indicators)
6. Receiver is responding to remote control
A selection of troubleshooting tips is offered below.
Problem
A "No signal!" warning appears
on some or all channels
Remote
control
responding
Wrong time being displayed
The following channels cut out
or "No or bad signal!" appears:
DSF, Tele 5, HSE 24 and
Sonnenklar TV
Troubleshooting
Batteries may be discharged
no
longer
Remote control code has been
changed inadvertently
"Summer Time" setting wrong.
An incorrect time was imported
from the reception signal
DECT telephones operate on
the same frequency as these
channels.
occur due to inadequate level
or poor shielding of cable
Cause
Interference
may
Remedy
Consult an antenna specialist
to have it checked and repaired
as
necessary.
Check
settings made in the "Settings",
"Antenna & Satellite", "Tuner
Confi guration"
menu,
change them if necessary.
Check the batteries
By simultaneously pressing the
Back button in conjunction with
buttons on the number pad (1-8)
the remote control code can be
changed. Your receiver requires
the remote control code "1". For
this
purpose
simultaneously
press
the
"Back"
"1" buttons.
Check "Summer Time Enabled"
in
the
"Settings"
"Date
Time Setup" menu and change
it as necessary Use the power
switch to switch the receiver
off from the current channel,
e.g. Das Erste or ZDF, wait
10 seconds and then switch
it back on
Consult your antenna specialist
the
and
and
and
93
Advertisement
Table of Contents
