Table of Contents
Advertisement
SEARCH CHANNELS (CHANNEL SEARCH)
MANUAL (CHANNEL) SEARCH
The
buttons allow you to select different sets of parameters for the search.
Start frequency
Use the
buttons to select the start frequency for the search.
Stop frequency
Use the
buttons to select the end frequency for the search.
Channel Search Mode
Use the
buttons to select whether you wish to search "free and scrambled" or "only free" channels.
Network Search
Use the
buttons (On/Off) to select whether a network search should be performed. If you set
this to "On", the networking of the transmission channels enables additional transmission channels
that have not yet been saved to be located. They are then saved and searched for new channels
in the same way as the existing channels.
If you set this to "Off", only the factory-set frequency range will be searched.
When you have made your settings, use the
the
button to start searching. You can cancel the search at any time by pressing the
During the search you will see a display that shows you the progress of the search and the channels
found so far. Newly found channels are identifi ed with the designation "New" after the channel name.
42
buttons to select "Start Search" and press
button.
Advertisement
Table of Contents
