Installing The System - Marport PRO M6 Service Manual

1. Connect the screen and plug in the installation USB key.
2. Press to switch on the Mx computer.
3. When the dialog appears, select the new type of Mx system to be installed.
4. Follow the same guidelines as the previous topic.
Marport technicians or dealers need to connect the different components of the
system.
1. Check that you have all the items needed for the installation (See Equipment List
(on page 13))
2. Install the hydrophones and their cables, or find the cables from hydrophones
that have already been installed.
3. Route the hydrophone cables toward the junction boxes.
4. Put the receivers elevated and/or fixed vertically on a wall in a dry and
clean area, as close as possible to the hydrophones. If the receivers are in a
closed environment, make sure it is enough ventilated and that the ambient
temperature does not exceed 55 °C (131 °F).
Note: Make sure that the cables from the junction boxes are long enough
to reach the receivers.
5. Install the Mac computer and Mx computer elevated and/or fixed vertically on a
wall, in a dry and ventilated area, without dust, in the wheelhouse.
CAUTION: The receivers are water resistant but not waterproof. The
computers are not water resistant. In order to prevent the equipment
from being damaged by water:
◦ Do not install the receiver and computer directly on the floor.
◦ The cable connectors must not point upwards.
6. Install the monitor(s).
7. Install the loudspeakers, if applicable.
8. Connect the Mac, Mx computer and receivers according to System Cabling (on
page 73).
9. You can switch on the computer.

Installing the System

M6 PRO | V7 | Installation
71