Table of Contents
Advertisement
Maintenance and Troubleshooting
Read this section for troubleshooting and maintenance information.
Checking Noise Interference
Use the spectrum analyzer to check the noise level of the hydrophones and check for
interference.
1. Click Add
to create a new page on which you will add the spectrum analyzer(s).
2. Right-click the IP address of the receiver in the status bar and click Start
Spectrum.
3. Open the control panels and go to the Mx panel.
4. Go to Hydrophone data, then drag and drop Spectrum data to a page. These
data appear only when the spectrum has been started.
M6 PRO | V7 | Maintenance and Troubleshooting
99
Advertisement
Table of Contents
Troubleshooting
