Introduction; Description; Instructions; Mic/Line Xlr Input - PROEL PLAYMIX 6 User Manual

INTRODUCTION

Thank you for choosing this PROEL product and for your trust in our brand, synonymous of accuracy, high quality
and reliability. All our products are CE approved and designed for continuous use in professional applications.

DESCRIPTION

PLAYMIX is a series of mixers created by PROEL to offer in a very compact and stylish package a high inputs
density, a full set of features and a superior audio quality, at a very convenient price point.
PLAYMIX mixers are available in 3 models, with the same channel and master functions, but offering 6, 8 or 10
inputs respectively. The mono MIC/LINE channels feature low-noise, high-headroom microphone preamps, 3-
band EQ with sweep MIDs and HPF, and 60mm control faders, for a full control of your sound.
All models feature an advanced DIGITAL section with LCD display, including:
- A high-quality 24-bit built-in DSP with 100 studio-grade presets of single and combined effect
(REVERBS, DELAYS, MODULATIONS)
- A 48KHz stereo USB audio interface for playing/recording thru PC connection
- A built-in MP3 player from USB memory key or BLUETOOTH interface
- On-the-go stereo recording on USB memory key
Carefully designed and engineered in Italy by PROEL, PLAYMIX mixers are hosted in rugged cases, providing
extended durability for a stage-proof use and they offer in an ultra-compact format the performance of
professional consoles, delivering a clean and accurate sound for a wide range of applications.

INSTRUCTIONS

NOTE: the three models differ only by the number of MONO channels, 2, 4 and 6 respectively. The
STEREO channels (2) and the MASTER section are the same for all the three models. The following
instructions refer to the channel numbering of PLAYMIX6.

1. MIC/LINE XLR input

This is a female XLR connector that accepts a balanced input from microphones, instruments or line audio
devices. The XLR input is wired as follows:
Pin 1 = shield or ground
Pin 2 = + positive or "hot"
Pin 3 = - negative or "cold"

2. MIC/LINE JACK input

This is a female JACK connector that accepts a balanced input from microphones, instruments or line audio
devices. The JACK input is wired as follows:
Tip = + positive or "hot"
Ring = - negative or "cold"
Sleeve = shield or ground
When connecting an unbalanced signal, wire them as follows:
Tip = + positive or "hot"
Sleeve = shield or ground

3. LINE/-30dB switch

Pressing this button, a 30dB attenuation is engaged on both XLR and JACK inputs. Use this button when
connecting a LINE output device or, in general, to avoid the clipping (PEAK LED flashing) when a high-level
signal is connected.
5