Fx Level Control; Mp3 Player/Recorder; Usb Port; Usb Bt Switch - PROEL PLAYMIX 6 User Manual

Available languages

24. FX LEVEL control

It adjusts the level of the internal effect signal sent to the MAIN MIX outputs.

This is the MP3 PLAYER/RECORDER section. The display shows the player's current status and the buttons

below allow to control it. The player can operate with a USB PENDRIVE or with a COMPUTER or as

BLUETOOTH player. See further in this manual the operating instructions for the MP3 PLAYER/RECORDER.

This is the USB port to which you can connect a USB pendrive or a PC. For the connection to a PC use the

same USB-A / USB-A cable provided with the power adapter.

IMPORTANT: when a personal computer is

connected to the front panel USB port, the

computer supplies power to the mixer

through this port. Therefore, the rear USB

port and AC/DC adapter should not be

connected. Make sure the PC USB port is

capable of powering the mixer, because it

may happen that some old computers do not

have enough power on the USB port.

27. CH / USB BT switch

This switch allows to select the inputs for second STEREO channel between its physical JACK connectors and

the BT / MP3 player.

The MAIN MIX controls the output level just before the MAIN MIX and HEADPHONE/C.ROOM outputs. When

the potentiometer is fully down the MAIN MIX is off, while the "0" indicates a +4dBu nominal output level.

Typically, this control is set near the "0" label and left alone, but it can be used for song fadeouts or quick

system-wide mutes.

29. MAIN MIX L & R XLR output

These XLR and provide a line-level signal that represents the fully mixed stereo signal controlled by the MAIN

MIX. Connect these to the inputs of your power amplifier, powered speaker or other audio processors.

Table of Contents

Playmix 8 Playmix 10