30. PHONES and C.ROOM level control
This controls the PHONES and C.ROOM output's level.
31. PHONES stereo jack output
STEREO JACK connector for the headphones output. The signal is the same of MAIN MIX outputs.
32. C.ROOM jack output
These JACK connectors provide a line-level signal that can be used to monitor the MAIN MIX program or as
an additional output.
33. L & R LEVEL meters
The level meters are made of two columns of four LEDs with three colors to indicate different ranges of signal
level:
• green = shows the nominal operative level of the signal (from -10 to 0 dB)
• yellow = shows the max operative level of the signal (+3 dB)
• red = shows an excessive signal level (+6dB).
NOTICE: For correct use, the RED LEDs must always remain OFF except for occasional short
periods.
34. ON LED
Indicates when the mixer is switched on.
35. POWER switch
Switch this one on and your mixer has power. Switch it off and it doesn't. Make sure that all master output
knobs are turned all the way down when powering your mixer up or down.
36. DC IN 5V 2A supply socket input
Here's where you plug in your mixer's external power supply. You should always connect your power supply
to the mixer before you plug the power supply into an electrical outlet.
IMPORTANT: while the supply socket is shaped like a typical USB socket, it cannot be used to
connect a computer.
10