Aas1 - ICP DAS USA ZT-2005-C8 User Manual

5.2.16

$AAS1

Description
This command is used to reload the factory default calibration parametersfor a
specified module, including the internal calibration parameters.
Syntax
$AAS1[CHKSUM](CR)
$ Delimiter character
AA The address of the module where the default parameters are to be
reloadedin hexadecimal format (01 to FF)
S1 The command to reload the factory default calibration parameters.
Response
Valid Command
Invalid Command
! Delimiter character to indicate a valid command
? Delimiter character to indicate an invalid command
AA The address of the responding module in hexadecimal format (01 to FF)
There will be no response if the command syntax is incorrect, there is a
communication error, or there is no module with the specified address.
Examples
Command $1BS1
Response !1B
Sends a command to reload the factory default calibration parameters for module
27 and returns a response indicating that the command was successful.
ICP DAS, ZT-2005-C8 User Manual, Version v1.0.1
Copyright © 2014 by ICP DAS Co., Ltd. All Rights Reserved.
!AASC[CHKSUM](CR)
?AA[CHKSUM](CR)
Page 34