Starting The Zt-2005-C8 - ICP DAS USA ZT-2005-C8 User Manual

3.3 Starting the ZT-2005-C8

As the ZigBee network is controlled by the ZigBee Coordinator, the
ZT-2550/ZT-2570 (ZigBee Coordinator) must be configured first. Refer to the documents
section below for full details of how to configure these devices.
Once configuration of the ZigBee Coordinator has been completed, set the "ZB PID"
and "ZB Channel" values for the ZT-2000 I/O device to the same values as the network,
and then reboot the device. The module will automatically start to function on the ZigBee
network using the default protocol.
※ Documents：
http://ftp.icpdas.com.tw/pub/cd/usbcd/napdos/zigbee/zt_series/document/zt-255x/
http://ftp.icpdas.com.tw/pub/cd/usbcd/napdos/zigbee/zt_series/document/zt-257x/
※ Configuration Utility (Used to configure ZigBee Coordinator)：
http://ftp.icpdas.com.tw/pub/cd/usbcd/napdos/zigbee/zt_series/utility/
ICP DAS, ZT-2005-C8 User Manual, Version v1.0.1
Copyright © 2014 by ICP DAS Co., Ltd. All Rights Reserved.
Page 13