Table of Contents
Advertisement
POWER PRO User's Manual
Using the POWER PRO
Power (ON/OFF) Switch
The POWER PRO uses a low-profile piezo switch for on/off control. Switch feedback is tied to the PWR LED. When the
switch is pressed the PWR LED will turn white. Use the table below to perform functions controlled by the on/off switch.
POWER PRO OFF
Show charge level
POWER PRO OFF
Turn ON
POWER PRO OFF
Enter storage mode
POWER PRO ON
Turn OFF
When you initiate Storage mode, the LEDs blink 3 times and then the battery disconnects. Apply external power to cancel
Storage mode.
•
•
Introduction
Specifications
support.dtsweb.com
Brief press, <1 s.
Press and hold for 1 s.
Press and hold for 6 s.
Press and hold for 2 s.
•
Using the POWER PRO
DataPRO Software Interface
Capacity displayed.
See
Power (PWR) Indicator
PWR LED will turn white when pressed, release
when it turns blue.
Hold switch until all indicator LEDs flash white.
Apply external power to exit storage mode when
using only the internal battery.
PWR LED will turn white when pressed, release
when it turns blue.
•
Care & Handling
11
August 2022
•
•
Connectors
Support
10400-00210-MAN (Rev. 0)
Advertisement
Table of Contents
Need help?
Do you have a question about the POWER PRO and is the answer not in the manual?