Connectors Assembly And Disassembly - RACOM RAy3-11 User Manual

Installation

4.4. Connectors assembly and disassembly

The unit is equipped with 3 connector slots described in detail (including connectors' pin-outs) in Sec-
tion 1.3, "Ethernet + power interfaces" and Section 1.4, "Service interfaces". Use only standard coun-
terparts to these connectors.
Fig. 4.13: Slots ETH1+POE, ETH2
A set of standard bushing and plugs is delivered with each RAy unit as an accessory ACS-RAy
rubber sealing for each bushing is delivered with three different internal diameters to fit different cable
diameters. The rubber is diagonally cut to enable sealing of cables with pre-installed connectors.
If the lengthening of the bushing is needed use the long bushing delivered within standard accessory
28
kit ACS-RAy2 or purchased separately as an option SET-BUSH65
space for connector) or the long extension OTH-BUSH-EXT500
Important
Before connecting the RAy unit to the power supply and/or to the user network it must be
grounded according to Section 4.3.3, "RAy unit grounding".
All cables have to be secured by appropriate bushings which must be fitted with relevant O-
rings and carefully tightened in, according the instructions below.
Remaining connector slots on RAy unit has to be secured by plugs (including the original
plugs in the flanges). Those must be fitted with O-rings and carefully tightened as well. Other-
wise, the unit is not protected against moisture intake through connectors and can not guar-
antee unit functionality.
27
https://www.racom.eu/eng/products/microwave-link.html#accessories_kit
28
https://www.racom.eu/eng/products/microwave-link.html#accessories_kit
29
https://www.racom.eu/eng/products/microwave-link.html#accessories_cable
30
https://webservice-new.racom.eu/main/eshop.detail?i=1513
60
Fig. 4.14: Slot S
29
30
(adds up to 50 cm).
RAy3 Microwave Link – © RACOM s.r.o.
(providing 65 mm long inner
27
. The