P Egress - RACOM RAy3-11 User Manual

5.5.3.3. 802.1p egress

Fig. 5.27: Menu Switch settings > QoS > 802.1p egress
Frame priority for 802.1p mapping
Frame priority value to which the following Green and Yellow parameters (VID marking, PCP
marking and PCP) belong to.
VID marking
Enable/disable VID marking for the given Frame priority. When the parameter is disabled frames
assigned with this FPri in ingress will not get their VID field updated even if the frame egresses
Tagged (normally all egressing Tagged frames get their VID updated to the value assigned in in-
gress).
PCP marking
Enable/disable PCP marking for the given Frame priority. When the parameter is disabled frames
assigned with this FPri in ingress will not get their PCP & CFI fields updated even if the frame
egresses Tagged (normally all egressing Tagged frames get their FPri & CFI bits updated to the
value assigned in ingress).
802.1p frame PCP
Frame Priority Code Point. This parameter contains the new PCP or FPri value that is assigned to
frames that egress this port. The FPri assigned to the frame in ingress is used to access this table.
© RACOM s.r.o. – RAy3 Microwave Link
Configuration
131