Kia SORENTO HEV 2023 Manual page 217

Features of your vehicle
Press START button with key (for
smart key system)
僅 This warning message appears if you
press the ENGINE START/STOP But-
ton whilst the warning message "Key
not detected" is illuminating.
僅 At this time, the immobiliser indicator
light blinks.
Check BCW system (if equipped)
This warning message is displayed if
there is a problem with Blind spot Colli-
sion Warning. In this case, we recom-
mend that you have the vehicle
inspected by an authorised Kia dealer/
service partner.
Coasting guide (if equipped)
OMQ4PH050357L
A chime will sound and the coasting
guide indicator will be displayed to
inform the driver when to take the foot
off the accelerator by anticipating a
decelerating event* based on the analy-
sis of driving routes and road conditions
stored in the navigation system. It
encourages the driver to remove the
foot from the pedal and allow coasting
down the road with EV motor only. This
helps preventing unnecessary fuel con-
sumption and increases fuel efficiency.
* Example of a deceleration event is
going down an extended hill, slowing
down approaching a toll booth, and
approaching reduced speed zones.
僅 User settings
Press the ENGINE START/STOP but-
ton and put the shift dial in P (Park). In
the User Settings Mode, select Driver
assistance, Coasting Guide, and then
On to turn on the system. Cancel the
selection of coasting guide to turn off
the system. For the explanation of the
system, press and hold the [OK] but-
ton.
僅 Operation conditions
To activate the system, take the fol-
lowing procedures. Enter your desti-
nation information on the navigation
and select the driving route. Select the
ECO mode in the Integrated Driving
Control System. Then, satisfy the fol-
lowing:
- The driving speed should be
between 30 km/h (19 mph) and 160
km/h (99 mph).
* The operating speed may vary due to
difference between instrument cluster
and navigation effected by tyre infla-
tion level.
Unplug vehicle to start (Plug-in
hybrid vehicle)
The message is displayed when you
start the engine without unplugging the
charging cable. Unplug the charging
cable, and then start the vehicle.
Remaining Time (Plug-in hybrid
vehicle)
The message is displayed to notify the
remaining time to fully charge the bat-
tery.
LCD displays
5
5 87