Kia SORENTO HEV 2023 Manual page 143

Features of your vehicle
hazard warning lights won't oper-
ate and theft-alarm will not arm.
After this, if the tailgate and engine
bonnet are closed, the hazard
warning lights will blink once.
僅 Lock the doors by pressing the lock
button on the smart key. After com-
pletion of the steps above, the haz-
ard warning lights will operate once
to indicate that the system is
armed. If any door (and tailgate) or
engine bonnet remains open, the
hazard warning lights won't oper-
ate and theft-alarm will not arm.
After this, if all doors (and tailgate)
and engine bonnet are closed, the
hazard warning lights blink once.
Using the remote key
Park the vehicle and stop the engine.
Arm the system as described below.
1. Turn off the engine and remove the
ignition key from the ignition switch.
2. Make sure that all doors (and tailgate),
the engine bonnet are closed and
latched.
3. Lock the doors by pressing the lock
button on the remote key. After com-
pletion of the steps above, the hazard
warning lights will blink once to indi-
cate that the system is armed. If any
door (and tailgate) or engine bonnet
remains open, the hazard warning
lights won't operate and theft-alarm
will not arm. After this, if all doors (and
tailgate) and engine bonnet are
closed, the hazard warning lights blink
once.
Ultrasonic Intrusion Protection
(UIP) (if equipped)
OMQ4040521R
僅 To cancel the sensor operation, go to
'Settings → Convenience' and turn
Ultrasonic Intrusion Protection to OFF.
僅 If the function is armed when the sen-
sor is in the OFF status, the intrusion/
tilt sensor will not operate.
Then, the alarm will be activated when
the function meets the intrusion/tilt
sensor off condition of "Theft-alarm"
stage.
To reactivate the sensor operation, go
to 'Settings → Convenience' and turn
Ultrasonic Intrusion Protection to ON
again.
CAUTION
僅 Do not activate the sensor if there are
any chances the vehicle tilts by the
outward influences (for example, ferry
boat travelling, tower parking etc.),
because it could cause the siren to
sound inadvertently.
僅 Make sure all windows are close whilst
the function operates. If not, the sen-
sor detects the inadvertent movement
inside the vehicle (for example, blow-
ing a wind or entering a butterfly) and
it makes the siren sounds.
Keys
5
5 13