Hsc Interface; Omnivision Interface - Analog Devices ADSP-BF53x EZ-Extender 1 Manual

• One OmniVision camera interface connector (
• One LCD interface connector (
Bidirectional drivers connect the Parallel Peripheral Interface (PPI) of the
ADSP-BF53x Blackfin processor to all of the OmniVision and HSC con-
nectors. A clock circuit allows multiple options for PPI interface clocking.

HSC Interface

As mentioned in
types of High-Speed Converter evaluation boards supported by the
EZ-Extender:
• Analog-to-Digital Converter boards
• Digital-to-Analog Converter boards
• Mixed-signal boards
The HSC interface employs two connectors,
is a 40-pin, 0.1 in. spacing, right angle, female socket for interfacing with
ADC evaluation boards. The
straight header intended for interfacing with DAC evaluation boards.
Both connectors provide all the necessary signals to transmit and receive
data to and from HSC evaluation boards.
The RJ45 connector (
ming the internal registers of some high-speed converters.

OmniVision Interface

The OmniVision connector is a 32-pin, 0.1 in. spacing, right angle,
female socket. The connector provides all of the necessary control and
data signals to interface with the OmniVision OV6630AA single-chip
CMOS CIF color digital camera module.
ADSP-BF53x EZ-Extender 1 Manual
EZ-Extender Hardware Reference
"Connecting EZ-Extender" on page
connector is a 40-pin, 0.1 in. spacing,
J4
) provides the processor's SPI signals for program-
J1
)
J2
)
P8
1-2, there are three
and . The
J3 J4
connector
J3
2-3