Set Up The Machine - Wallenstein LXT95 Operator's Manual

Operating Instructions

6.12 Set Up the Machine

WARNING!
Read and understand the Operating Safety on
page 32.
WARNING!
Always use the machine outdoors and park
the machine in a position where the prevailing
winds blow the engine exhaust away from the
operator. Exhaust from the engine contains
carbon monoxide (CO) that can accumulate to a
dangerous level, even in an area with good air
fl ow.
WARNING!
Before operating the machine, attach it to a
tow vehicle and lower the stabilizers. Keep the
machine attached to the tow vehicle and the
stabilizers fi rmly on the ground during operation.
If the machine is not attached to a tow vehicle or
the stabilizers are up, it can tip over and cause
serious injury or death.
Position the machine as close to the log stack as possible (this
makes the log grapple easier to use, especially with heavy logs).
However, the log stack must not interfere with safe loading or
unloading of the machine.
The numbers in Figure 33 on page 43 refer to the following
instruction step numbers.
1. Park the tow vehicle and machine at the work site.
For more information, see Work Site on page 11.
2. Engage the tow vehicle parking brake.
Leave the machine attached to the tow vehicle.
3. Lower the trailer jack for added stability.
For instructions, see Trailer Jack on page 53.
4. Turn the operator control panel.
Position the operator controls on the opposite side of the
machine from the log stack (it is necessary for the operator
to face the work area). For more information, see Operator
Control Panel Lock on page 26.
5. Start the machine.
For instructions, see Start the Machine on page 41.
6. Extend the two stabilizers.
For each stabilizer:
a. Disengage the stabilizer latch.
For instructions, see Stabilizer Latch on page 27.
b. Use the LH or RH Stabilizer Control lever to extend the
stabilizer.
Make sure that both stabilizers are fully on the ground.
7. Remove the boom lock pin from the main boom.
Place the pin in the storage bracket that is on the side of the
main boom.
8. Test each hydraulic control to make sure that it functions
correctly.
9. For the LXT95 model: adjust the sliding axle.
For instructions, see LXT95 Sliding Axle Operation on page
40.
W006
10. Position the log grapple:
a. Open the log grapple.
b. Use the boom controls to raise the log grapple higher
than the bunk posts.
c. Turn the boom to position the log grapple over the work
area.
6.12.1 Rugged Terrain
The machine can be used in a variety of conditions, including
rugged terrain. However, the area must be clear, and the ground
W097
must be firm and level.
In an area where the terrain is rugged:
• Use the stabilizers to keep the machine as level as possible.
• Make sure that the tow vehicle parking brake is on.
• Put blocks in front and behind the tow vehicle wheels and
the machine wheels to prevent movement.
• Use extra caution and common sense.
42
LXT95 / LXT115
Log Loader Trailer