Function Of The Buttons - Gree XE73-44/E Owner's Manual

Wired Controller XE73-44/E

2.2 Function of the Buttons

No. Name
1
SWING/ENTER
3 ▲
7 ▼
6 FAN
4 MODE
5 FUNCTION
2 TIMER
8 ON/OFF
3+4 ▲+MODE
6+7 FAN+▼
3+7 ▲+▼
4+7 MODE+▼
2+5
TIMER+FUNCTION
2+5
TI MER+FUNCTION
5+6
FUNCTION + FAN
Table 2
Function selection and cancellation.
①
Setting of the up and down swing function.
②
Running temperature setting of the indoor unit, range:16~30°C(61~86°F).
①
Timer setting, range:0.5-24 hr.
②
Setting of the auto/low/medium low/medium/medium high/ high fan speed.
Setting of the Cooling/Heating/Fan/Dry/Auto mode of the indoor unit.
Switchover among the functions of Turbo/WiFi/E-heater/X-fan etc..
Timer setting.
Turn on/off the indoor unit.
Press them for 5s under off state of the unit to Enter/Cancel the Memory
function(If memory is set, indoor unit after power failure and then power
recovery will resume the original setting state. If not, the indoor unit is
defaulted to be off after power recovery. Memory off is default before
delivery.).
By pressing them at the same time under off state of the unit,
displayed on the wired controller for the cooling only unit, while
displayed on the wired controller for the cooling and heating unit.
Upon startup of the unit without malfunction or under off state of the
unit,press them at the same time for 5s to enter the lock state, in which
case, any other buttons won't respond the press. Repress them for 5s to
quit this state.
Under OFF state, the Celsius and Fahrenheit scales can be switched by
MODE
Under OFF state, it is available to go to the commissioning status by
FUNCTION
the temperature display area by pressing "MODE", then adjust the options
which is shown on the timer area by pressing "▲" and "▼". There are totally
four options, as follows:
Indoor ambient temperature is sensed by the return air temperature
①
sensor ( 01 displayed on the timer area).
Indoor ambient temperature is sensed by the wired controller (02
②
displayed on the timer area).
The return air temperature sensor is selected under the cooling, dry, or
③
fan mode; while the wired controller temperature sensor is selected under
the heating or auto mode. (03 is displayed on the timer area).
The wired controller temperature sensor is selected under the cooling,
④
dry, or fan mode; while the return air temperature sensor is selected under
the heating mode. (04 is displayed on the timer display area).
Under OFF state, it is available to go to the commissioning status by
pressing " " and "
FUNCTION
until "01" icon is shown at the temperature display area. The setting status
will be shown at timer area. Press "▲" and "▼" button to adjust and two
options are available: ① Three low levels (01) ; ② Three high levels (02).
Reset the WiFi function: Under off status, press "FUNCTION" + "FAN"
combination buttons on its wired controller for 5s. Once "oC" is displayed,
this indicates that reset was successful.
Function
5s.
TIMER
" for five seconds. Press "
TIMER
3
will be
will be
" button to
MODE