Function And Parameter; Functional Overview; Parameter Specifications - Gree ME20-24/D1(T) Owner's Manual

Intelligent Controller
would result in a fire hazard or even damages to this device.
For PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the equipment and shall be
easily accessible.
Do install this device inside the electric control cabinet which is located indoor and then is locked.
Do install this device where it will not be subject to the electromagnetic interference or heavy dust.
Be sure the specified adaptor is used; otherwise this device would work improperly or even be
damaged.
Be sure this device is setup in place; otherwise it would result in communication fault.
Be sure the communication line is connected to the correct interface; otherwise it would result in
communication fault.
After connection, lines should be protected with insulating tape to avoid oxidation and short circuits.
Risk of explosion if battery is replaced by an incorrect type, dispose of used batteries according to
the instructions.
Normal working conditions for Controller:
①Temperature : -20～60℃;
②Humidity: less than 85%,except for the condensation of dew;
③Location: indoor (it is highly recommended to install this product in the electric control cabinet), not
subject to direct sunlight, rain and snow etc.
Graphics in the instruction manual are for reference only.

3 Function and Parameter

3.1 Functional Overview

Intelligent Controller (Model: ME20-24/D1(T)) is used together with Intelligent
Remote Eudemon system, which can realize the supervision and control of
multi VRF systems. Using method for Intelligent Remote Eudemon system please
see the instruction manual of such software.
Applicable models: GMV6,GMV5S,GMV5,GMV water, GMV ES,GMV Tops,
GMV Star.

3.2 Parameter Specifications

3.2.1 Controller TCP/IP Parameter (Default)
IP Address:192.168.1.150
Subnet Mask:255.255.255.0
Default Controller:192.168.1.1
CAUTION:Before using the controller, configure the service IP and service port
WARNING!
CAUTION!
2