Replacing The Fuel Filter Of The Fuel/Water Separator; Cleaning The Engine Cooling System - Sullair 185CFM User Manual

185 T4F Kubota User Manual
1. Separator head
2. Fuel filter
3. Separator bowl
Figure 6-4: Fuel/water separator
6.9.5.2 Replacing the fuel filter of the fuel/water
separator
This machine is fitted with an electric fuel pump
that primes the fuel system as soon as the power
switch is turned on. A buzzing can be heard from
the pump when it is on. When changing filters,
this pump will prime the system with fuel.
1. Shut down the compressor.
4. Drain valve
5. Drain
NOTE
Subject to EAR, ECCN EAR99 and related export control restrictions.
2. Open the compressor canopy.
3. Remove the separator bowl by turning it to
the left.
4. Remove the old fuel filter by turning it to the left.
5. Install the new fuel filter by turning it to the
right until tight.
6. Install the separator bowl by turning it to the
right until tight.
7. Close the compressor canopy.
6.9.6

Cleaning the engine cooling system

1. Shut down the compressor.
2. Allow the compressor to cool to ambient
temperature.
3. Open the compressor canopy.
4. Disconnect the battery and tagout the
connection.
5. Close the compressor canopy.
6. Remove the eight (8) recessed hex cap
screws from the front louver.
7. Detach the front louver from the canopy.
8. Using a pressure washer, spray the
cooler and radiator from side-to-side,
starting at the top and moving down.
• Before using the pressure washer. consult
the pressure washer's owner's manual.
Stand directly in front of the compressor when
spraying. Spraying from the sides can damage
the cooler and radiator.
9. Open the compressor canopy.
10. Using a pressure washer, clean the fan
blades by blowing down through the fan
guards.
11. Allow the compressor to dry completely.
12. Connect the battery and remove the tagout.
13. Close the compressor canopy.
14. Attach the front louver to the canopy.
15. Install the eight (8) recessed hex cap
screws on the front louver.
02250216-781 R02
6: Maintenance
NOTICE
49