Removing The Engine Board/Power Supply - Kyocera Ecosys FS-600 Service Manual

Removing the engine board/power supply

Removing these parts requires separation of the top and bottom frames. First,
remove all covers, high-voltage board, drive unit, and the controller board
referring the above procedures.
The top and bottom frames are secured to each other by the screws at the left,
right, and the rear side of the printer.
Begin by removing screws on the right side of the printer. Remove screw ".
Detach connectors ! and #.
On the left side of the printer, remove two screws ".
5-19
Disassembly
Disassembly
FS-600/FS-680