Removing the paper feed roller
To remove the paper feed roller, use two steps as follows: "Slide the roller
leftwards. Note that the roller is spring-loaded. This disengages the right end of
the roller from the holding ledge in the printer. !While holding the roller in the
place, pull the right end towards you.
To reseat the paper feed roller, fit the left end hole (!-shaped) of the roller onto
the holding ledge in the printer. Press and hold the roller to the left side. Then
align the right end hole of the roller ( γ -shaped) with the right-hand sledge in the
printer. Let go off of the roller.
Left
D
5-24
Disassembly
Disassembly
Right
FS-600/FS-680