Removing The Ib-10 Board - Kyocera Ecosys FS-600 Service Manual

Removing the IB-10 board

To change the serial protocol from RS-232C to RS-422A, for example, carefully remove the
jumper connector on the IB-10 board. Reconnect to the pin position as shown in the diagram.
RS-232C
position
Replace the IB-10 board back into the printer. Secure the board by the thumb screws.
Serial interface—Option (IB-10)
RS-422A
position
A-7
Printer interface
Remove these
thumb screws.
FS-600/FS-680