Power Supply; Unpacking And Inspection - Kyocera FS-1750 Installation Manual

Hide thumbs Also See for FS-1750:

Table of Contents

Power Supply

The printer should not be on the same power circuit as an air conditioner, fluorescent light,

copier, or shredder, because these devices generate electrical noise on the power line. If it

must share a power circuit with equipment like this, a high-frequency noise filter or isola-

tion transformer is advisable. (Filters and transformers are available commercially.)

Avoid using plug multipliers to connect a large number of devices on the same circuit as the

printer.

If the power from the outlet itself appears to be unstable, a line stabilizer should be used. In

places where the voltage tends to fluctuate, it may be necessary to install a voltage regulator.

As the disconnect device is not incorporated in the printer's AC primary cir-

cuit, an easily accessible socket outlet must be provided near the equipment.

If the printer is used with the optional Sorter (SO-6) or Stacker (ST-20), in order

to avoid short-circuiting, it should be ensured that these devices are plugged

securely into their respective power outlets.

Da kein Trennschalter in den Wechselstrom-Primärkreis des Druckers einge-

baut ist, muß eine leicht zugängliche Steckdose in der Nähe des Gerätes

vorhanden sein.

Wenn der Drucker mit dem gesonderten Sorter (SO-6) oder Stapler (ST-20) ver-

wendet wird, muß darauf geachtet werden, daß diese Geräte einwandfrei an

separate Steckdosen angeschlossen sind, um Kurzschluß zu vermeiden.

The printer is packed as shown below. Unpack the printer following figures 1 and 2 on the

next page. While unpacking it, check that the listed parts are all accounted for.

Examine the package for any signs of damage that may have been caused during transpor-

tation. If the carton is found to be badly damaged, leave the carton unopened and immedi-

ately notify the dealer from whom you purchased the printer.

Save the box and other packing materials in case you have to repack the printer for trans-

portation at a later date.

2. Unpacking and Inspection

Table of Contents

Fs-3750