Machine Inspection - JLG 1230ES Operation And Safety Manual

• Check the work area for hazardous locations. Do not
operate the machine in hazardous environments unless
approved for that purpose by JLG.
• Ensure that the ground conditions are adequate to sup-
port the maximum tire load indicated on the tire load
decals located on the chassis adjacent to each wheel.
• Do not operate the machine when wind conditions exceed
28 mph (ANSI/CSA SPEC) /(CE/AUST SPEC) - Indoor Use
Only.
• This machine can be operated in nominal ambient tem-
o
peratures of 0 F to 104
to optimize operation outside of this temperature range.

Machine Inspection

• Do not operate this machine until the inspections and
functional checks have been performed as specified in
Section 2 of this manual.
• Do not operate this machine until it has been serviced and
maintained according to the maintenance and inspection
requirements as specified in the machine's Service and
Maintenance Manual.
• Ensure all safety devices are operating properly. Modifica-
tion of these devices is a safety violation.
3121221
o o o
F (-20 C to 40 C). Consult JLG
– JLG Lift –
SECTION 1 - SAFETY PRECAUTIONS
MODIFICATION OR ALTERATION OF AN AERIAL WORK PLATFORM
SHALL BE MADE ONLY WITH PRIOR WRITTEN PERMISSION FROM THE
MANUFACTURER
• Do not operate any machine on which the safety or
instruction placards or decals are missing or illegible.
• Check the machine for modifications to original compo-
nents. Ensure that any modifications have been approved
by JLG.
• Avoid accumulation of debris on platform deck. Keep
mud, oil, grease, and other slippery substances from foot-
wear and platform deck.
1-3