Installing The Mini Mezzanine Card - Dell PowerEdge MX760c Installation And Service Manual

Figure 111. Removing the mini Mezzanine card
NOTE: Install the connector cap on the I/O connector of the mini Mezzanine card, when not installed on system board.
Next steps
1. Follow the procedure listed in

Installing the mini Mezzanine card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
NOTE: The mini Mezzanine card is supported only on systems with two processors.
Steps
1. Remove the connector cap on the I/O connector of the mini Mezzanine card.
2. Pull the blue pull tag to raise the lever on the mini Mezzanine card.
3. Align the mini Mezzanine card connector with the connector on the system board.
4. Insert the mini Mezzanine card firmly until it is fully seated.
After working inside your
Safety instructions.
Before working inside your system
system.
Installing and removing system components 131