Table of Contents
Advertisement
NOTE:
Ensure latching features on processor retaining clip and heat sink are aligned during assembly.
Figure 79. Installing the heat sink onto the processor
Next steps
1.
Install the processor and heat sink
2.
Install the air
shroud.
3. Follow the procedure listed in
Installing the processor and heat sink module
Prerequisites
CAUTION:
Never remove the heat sink from a processor unless you intend to replace the processor. The heat
sink is necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air shroud
4. If installed, remove the processor dust cover.
Steps
1. Set the anti-tilt wires to the unlocked position on the heat sink (inward position).
2. Align the pin-1 indicator of the heat sink to the system board, and then place the processor and heat sink on the processor
socket.
CAUTION:
To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
104
Installing and removing system components
module.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
