Table of Contents
Advertisement
NOTE:
Ensure that the pin 1 indicator on the cold plate is aligned with the pin 1 indicator on the retaining clip before
placing the cold plate onto the processor retaining clip.
NOTE:
Ensure latching features on processor retaining clip and cold plate are aligned during assembly.
Figure 91. Installing the cold plate onto the processor
Next steps
1.
Installing a x4 2.5-inch and x8 E3.s liquid cooling
2. Follow the procedure listed in
Installing a x4 2.5-inch and x8 E3.s liquid cooling assembly
Steps
1. Set the Anti-Tilt wires to the unlocked position on the cold plate (inward position).
2. Align the pin 1 indicator of the cold plate to the system board, and then place the cold plate assembly unto the processor
sockets.
CAUTION:
To avoid damaging to the tubes, do not press down on the tubes.
NOTE:
Ensure that the processor and cold plate is held parallel to the system board to prevent damaging the
components.
114
Installing and removing system components
assembly.
After working inside your
system.
Advertisement
Table of Contents
