Table of Contents
Advertisement
Figure 74. Removing the processor retaining clip
Next steps
Replace the processor into a processor and heat sink module
Installing the processor into a processor and heat sink module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
NOTE:
The CPU assembly orientation between CPU 1 and CPU2 is reverse.
Steps
1. Place the processor in the processor tray.
NOTE:
Ensure that the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
2. Place the processor retaining clip on top of the processor that is in the processor tray aligning pin 1 indicator on the
processor.
NOTE:
Ensure that the pin 1 indicator on the retaining clip is aligned with the pin 1 indicator on the processor before
placing the retaining clip on the processor.
NOTE:
Ensure that the processor and the retaining clip are placed in the tray before you install the heat sink.
Safety
instructions.
Before working inside your
(PHM).
system.
Installing and removing system components
101
Advertisement
Table of Contents
