Table of Contents
Advertisement
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If you are replacing the system board, remove all the components that are listed in the
Steps
1. Unpack the new system board assembly.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
2. Holding the system board by its edges, lower the system board into the chassis.
Figure 118. Installing the system board
3. Holding the Mezz card brackets by its edges, lower the brackets into the system board.
4. Using the Phillips #2 screwdriver, tighten the screws that secure the system board to the chassis.
5. Using the Phillips #2 screwdriver, tighten the screws that secure the Mezz card brackets to the system board.
Next steps
1. Replace the following components:
a.
Trusted Platform Module(TPM)
NOTE:
The TPM Module must be replaced only while installing new system board.
b.
Internal USB key
c.
M.2 BOSS module
d.
Mini Mezzanine
e.
Mezzanine cards
f.
PERC card
g.
Drive cage
h.
Drive backplane
i.
Drives
Safety
instructions.
Before working inside your system
Remove the system board
Installing and removing system components
section.
137
Advertisement
Table of Contents
