Emerson GEODE CF370PN00 Owner's Manual page 7

3. Ceiling Fan Assembly
3.5
Carefully turn the partially assembled Ceiling Fan right
side up and place the Fan securely into the packing
styrofoam. Careful not to bend the Blades.
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 4.5" Downrod (Figure 5).
Remove the Pin from the 4.5" Downrod, then remove
the Hanger Ball (Figure 5).
Retain the Pin and Hanger Ball for reinstallation in
Step 3.12.
Note: Do not loosen the Screw that attaches the
Green Ground Wire to the Hanger Ball.
3.6
Separate, untwist and unkink the Three 80" Motor
Wires.
Route the Three 80" Black, Blue, and White Motor
Wires through the 4.5" Downrod (Figure 6).
3.7
Loosen the Two Phillips Head Set Screws in the Motor
Coupler for installation of the 4.5" Downrod (Figure 7).
Seat the 4.5" Downrod in the Motor Coupler (Figure 7).
Rotate and align the Two Downrod Clevis Pin Holes
with the Two Motor Coupler Clevis Pin Holes (Figure 7).
(Continued)
PIN
PHILLIPS HEAD SET SCREW (LOOSENED)
Figure 5
THREE 80" MOTOR
WIRES (UNTWISTED)
Figure 6
Figure 7
Please contact 1-800-654-3545 for further assistance
7
GREEN GROUND WIRE
4.5" DOWNROD
HANGER BALL
4.5" DOWNROD
emersonfans.com
ETL Model No.: CF370