Table of Contents
Advertisement
1. Connect the charging cable to the generator DC socket and connect it to the battery terminal
Connect the charging cable to the battery first, and then connect it to the generator. Disassembly
must start from the generator side, which prevents sparks start beside the battery.
When connecting the charging cable to the car battery, disconnect the battery ground wire first.
Remove the cable and then connect to the ground wire on battery after charging is complete. So
that even if you make the battery terminal contact with the car frame by accident, it can prevent
short circuit or spark.
Do not start the car when the generator is connected to the battery, otherwise it might damage the
generator.
Charging cable should be properly connected to the positive and negative terminals of the battery,
otherwise it will damage the generator or the battery.
Charge should be properly ventilated, and away from fireworks, because the battery will evaporate
flammable gas.
The battery contains sulfuric acid (electrolyte). Contact with skin or eyes can cause burns. Wear
protective clothing and mask.
Electrolyte is toxic, if the electrolyte splashed on the skin, immediately rinse with water.
If the electrolyte splashes into the eyes, rinse immediately with water for 15 minutes and seek
medical care.
If you accidentally swallow the electrolyte, drink plenty of water or milk immediately, and then
drink milk or vegetable oil with magnesium oxide and seek medical care.
Batteries and electrolytes should be placed where children are not accessible.
WARNING
WARNING
WARNING
Charging
Cable
23
Advertisement
Table of Contents
