Startup; Unit With Suction System; Unit With Upper Hopper; High Pressure Hose And Spray Gun - WAGNER Brillux SUPER FINISH 23 PRO SELECT Operating Manual

SuperFinish 23 Pro Select
4

STARTUP

Press the inlet valve pusher before start up.
This ensures that the valve is not blocked or
clogged.
4.1

UNIT WITH SUCTION SYSTEM

1. Ensure that the sealing surfaces of the connections are
clean.
Ensure that the red inlet (1) is inserted in the coating ma-
terial inlet (4).
2. Use the enclosed 41 mm wrench to screw the union nut
(2) at the suction tube(3) onto the coating material inlet
(4) and tighten it.
3. Screw the union nut (5) at the return tube(6) to the con-
nection (7) (22mm).
4.2

UNIT WITH UPPER HOPPER

1. Ensure that the sealing surfaces of the connections are
clean. Ensure that the red inlet (1) is inserted in the coat-
ing material inlet (4).
2. Screw the union nut (5) on the return pipe (6) onto the
connection (7).
3. Screw the upper hopper (8) onto the coating material in-
let (4).
4.3
1. Screw the high pressure hose (9) onto the hose connec-
2. Screw the spray gun (10) onto the high pressure hose
3. Tighten all union nuts on high pressure hose so that no
4. Screw the tip holder with the selected tip onto the spray
4.4
Before connecting the unit to the mains supply, ensure that
the line voltage matches that specified on the unit's rating
plate.
7
5
6
2
1
3
4

HIGH PRESSURE HOSE AND SPRAY GUN

tion
coating material can escape.
gun, align tip and tighten union nut.
When unscrewing the high pressure hose,
hold firmly on the hose connection with a
22mm wrench.

CONNECTION TO THE MAINS NETWORK

Connection must always be carried out via
an appropriately grounded safety outlet with
residual-current-operated circuit-breaker.
6
5
7
1
4
EN
STARTUP
10
8
9
39