General View Of Application; Application; Coating Material; Coating Materials With Sharp-Edged Additional Materials - WAGNER Brillux SUPER FINISH 23 PRO SELECT Operating Manual

SuperFinish 23 Pro Select
3

GENERAL VIEW OF APPLICATION /

DESCRIPTION OF UNIT
3.1

APPLICATION

SF 23 Pro Select is an electric driven unit for the airless atomi-
zation of different painting materials. Also it is able to feed the
internal feeded paint roller, which is available as accessory.
SF 23 Pro Select is made for jobs in the workshop and on the
building site.
The SF 23 Pro Select's device output is designed so that dis-
persions can be processed indoors and outdoors for small to
medium-sized objects.
When painting, the device is suitable for all kinds of typical
painting jobs, e.g.:
doors, door frames, balustrades, furniture, woodencladding,
fences, radiators (heating) and steel parts.
We recommend using the top container for paintwork.
3.2

COATING MATERIAL

Water- and solvent-based lacquers and paints or those con-
taining solvents, two-component coating materials, disper-
sion and latex paints.
No other materials should be used for spraying without WAG-
NER's approval.
Pay attention to the Airless quality of the
coating materials to be processed.
The unit is able to process coating materials with up to
20,000 mPas. If highly viscous coating materials cannot be tak-
en in or the performance of the unit is to low, the paint must
be diluted in accordance with the manufacturer's instructions.
Attention: Make sure, when stirring up with
motor-driven agitators that no air bubbles
are stirred in. Air bubbles disturb when spray-
ing and can, in fact, lead to interruption of
operation.
3.2.1
COATING MATERIALS WITH SHARP-EDGED
ADDITIONAL MATERIALS
These particles have a strong wear and tear effect on valves
and tips, but also on the heating hose and spray gun. This im-
pairs the durability of these wearing parts considerably.
GENERAL VIEW OF APPLICATION / DESCRIPTION OF UNIT
3.2.2

FILTERING

Sufficient filtering is required for fault-free operation. To this
purpose the unit is equipped with a suction filter (Item 1) and
an insertion filter in the spray gun (Item 2). Regular inspec-
tion of these filters for damage or soiling is urgently recom-
mended.
A high-pressure filter (Item 3) -available as accessory- is rising
up the filtering surface and will make the work more comfort-
able.
2
3.3

AIRLESS PROCESS

The main area of application are thick layers of highly viscous
coating material.
At the SF 23 Pro Select unit a diaphragm pump takes in the
coating materials and transports it via a high-pressure hose
to the spray gun with the airless tip. Here the coating material
atomizes since it is pressed through the tip core at a maximum
pressure of 25 MPa (250 bar, 3625 psi). This high pressure has
the effect of micro fine atomisation of the coating material.
As no air is used in this process, it is described as an AIRLESS
process.
This method of spraying has the advantages of finest atomisa-
tion, cloudless operation (depending of a correct unit adjust-
ment) and a smooth, bubblefree surface. As well as these, the
advantages of the speed of work and convenience must be
mentioned.
EN
3
1
35