General View Of Application; Application; Coating Materials - WAGNER Super Finish 27 Operating Manual

•
Electrostatic charging (formation of sparks or
flame)
Under certain circumstances, electrostatic charg-
ing can occur on the unit due to the rate of flow of
the coating material when spraying. On discharg-
ing this can result in the emergence of sparks or
Danger
fire. It is therefore necessary that the unit is always
earthed through the electrical installation. The connection
must take place through a correctly earthed two-pole-and-
earth socket outlet.
An electrostatic charging of spray guns and the high-pressure
hose is discharged through the high-pressure hose. For this
reason the electric resistance between the connections of the
high-pressure hose must be equal to or lower than 1 MΩ.
•
Using unit on construction sites
Connection to the mains only through a special feed
point, e.g. through an error protection installation with
INF ≤ 30 mA.
•
Loading the socket at the unit
Do not load the socket with more than 1000 Watt. Unroll
any connected cable drum completely.
•
Ventilation when spraying in rooms
Adequate ventilation must be guaranteed for the removal
of the solvent vapours.
•
Suction installations
These are to be set-up by the user of the unit according to lo-
cal regulations.
•
Earthing of the object
The object to be coated must be earthed.
•
Cleaning units with solvents
When cleaning the unit with solvents, the solvent
should never be sprayed or pumped back into a
container with a small opening (bunghole). An ex-
plosive gas/air mixture can be produced. The con-
Danger
tainer must be earthed.
•
Cleaning the unit
Danger of short circuit through penetrating
water!
Never spray down the unit with high-pressure
or high-pressure steam cleaners.
Danger
Socket on unit
Only carry out damp cleaning in the area of the socket
and the multifunction switch when the mains plug is re-
moved.
•
Work or repairs on the electrical equipment
Only have this work carried out by a qualified electrician.
No liability will be taken for incorrect installation.
Super Finish 27 • 31
GB
Safety regulations / General view of application
•
Working on electrical components
Remove the mains plug from the socket for all such
works.
•
Setting-up on uneven surfaces
The front side of the unit must point downwards to prevent
sliding away. (fig. 1)

2.

GENERAL VIEW OF APPLICATION

2.1

APPLICATION

All painting jobs in the workshop and on the building site,
small and large-area dispersion work with the spray gun or in-
ternally fed Airless roller, corrosion and fire protection.
Examples of object of spraying
Doors, door frames, balustrades, furniture, wooden cladding,
fences, radiators (heating) and steel parts, internal ceilings and
walls, and also façades, basement garages, fire and noise pro-
tection for steel and wooden construction.
2.2

COATING MATERIALS

Processible coating materials
Pay attention to the Airless quality of the
i
coating materials to be processed.
Dilutable lacquers and paints or those containing solvents,
two-component coating materials, dispersions, latex paints,
façade paints, roof and attic coatings, fire and corrosion pro-
tection material.
No other materials should be used for spraying without WAG-
NER's approval.
29