Important Notices; Important Deployment Information; Service & Safety; Safety Warnings - Redline Connect Series Installation Manuallines

CONNECT-OWS
1

Important Notices

1.1

Important Deployment Information

IMPORTANT: Refer to the RDL-3000 Family User Manual for detailed regulatory
information. Refer to this document before deploying and powering Connect systems in
the field.
1.2 Service & Safety

Safety Warnings


WARNING - MICROWAVE TRANSMISSIONS: Do not operate or work in close
proximity to this equipment without first having proper training or knowledge of
microwave radio operation.

Read this manual and follow all operating and safety instructions.

Installation of the system must be contracted to a professional installer.

Keep all product information for future reference.

The power requirements are indicated on the product-marking label. Do not exceed
the described limits.

The unit must not be located near power lines or other electrical power circuits.

Disconnect the power before cleaning, or when the unit is not be in-use for an
extended period.

The system must be properly grounded to protect against power surges and
accumulated static electricity. The user is responsible for installing this device in
accordance with the local electrical codes: correct installation procedures for
grounding the unit, mast, lead-in wire and discharge unit, location of discharge unit,
size of grounding conductors and connection requirements for grounding electrodes.

General Warnings

Redline recommendations for maximum safety include the following:

Do not operate microwave equipment without first having proper training or
knowledge of microwave radio operation.

Do not operate the microwave equipment without an appropriate antenna port
termination, or antenna.

Do not look into or stand in front of an antenna.

Do not swing or aim an antenna at nearby persons while the equipment is operating.

Check to ensure that the area around the antenna is clear of personnel prior to
turning the transmitter on.

In locations where other antennas are installed, do not proceed with an installation
without first determining the RF/µW exposure risk. Where necessary have the
relevant transmitters turned off or wear a protective suit for the duration of the
installation.

Warning Symbols

These symbols may be encountered during installation or troubleshooting. These
warning symbols mean danger. Bodily injury may result if you are not aware of the safety
hazards involved in working with electrical equipment and radio transmitters. Familiarize
yourself with standard safety practices before continuing.
70-00200-02-00
Installation Guidelines
Proprietary Redline Communications © 2014
Chapter 1
Page 9 of 70 December 3, 2014