Configure Connect-Ows System; Required Materials; Table 24: Installation: Installer Supplied Materials; Figure 42: Configuration: Connect-Ows System Configuration Block Diagram - Redline Connect Series Installation Manuallines

CONNECT-OWS
4.4

Configure Connect-OWS System

All configuration is performed using the Connect-OWS web interface. Use the following
steps to configure the Connect-OWS serial ports and setup a link to the base station:
Connect an Ethernet cable from the test PC to Connect-OWS port ETH 1 or ETH 2.
1.
Power-on the Connect-OWS.
2.
Open a Web browser and login to the Connect-OWS management interface.
3.
Configure the network, serial ports and wireless settings.
4.

Figure 42: Configuration: Connect-OWS System Configuration Block Diagram

4.4.1

Required Materials

Configuration of the Connect system settings requires additional equipment and
materials supplied by the installer. The following list is a guideline only, and additional
materials may be required based on local conditions at each installation site.
# Item
1 Cabinet
2 Ethernet Cable
70-00200-02-00
Installation Guidelines

Table 24: Installation: Installer Supplied Materials

Description
Portable computer with Web browser.
crossover
A CAT-5e
Proprietary Redline Communications © 2014
cable terminated with RJ-45 at both ends.
Page 53 of 70 December 3, 2014