Peristaltic Rinse Aid Dispenser Operation (Optional - Pict. 3); Detergent Dispenser Retrofit; Electrical Connection; Water Connection - Bartscher 110530 Instructions For Installation, Use And Maintenance Manual

1.7 Peristaltic rinse aid dispenser operation (optional - pict. 3)

Operation: The rinse aid dispenser is a peristaltic pump.
The rinse aid dispenser is also activated when the tank is loaded.

Water connection:

C
15186/T
Adjustment: With each rinse cycle, the dispenser draws an amount of rinse aid, adjustable from 0
to 4 gr.
To adjust the capacity of the pump, use a screwdriver (see pict. 3).
THE DISPENSERS ARE PRE-SET TO A 1,65 gr INTAKE OF PRODUCT FOLLOWING A TEST
PHASE SYSTEM CHECK. THIS MEASUREMENT SHOULD BE ADJUSTED ACCORDING TO THE
TYPE OF RINSE AID USED AND WATER HARDNESS.
code 15985/G
pict. 3

2. DETERGENT DISPENSER RETROFIT

2.1 Electrical connection

Follow the wiring diagram attached to the machine.
2.2 Water connection
a) A Ø 12 hole must be made on the back of the appliance.
In some appliances the hole has already been made and is closed
with a plastic cap.
Remove the cap from the hole and fi t the delivery connection.
b) Otherwise, drill one of the same diameter as the injector on the back
part of the tub (see pict. 5. This operation must be carried out by the
Technical Service.
The hole must be made above the water level.
Important: make the hole in a position distant from the overfl ow tube,
so that detergent does not fl ow out immediately. Fix the dispenser in
a vertical position with tube connectors turned downwards, making
sure not to place it on energized components.
Clean the inside of the machine from any drilling residual.
c) Correctly mount the injector
d) Connect the suction tube to the suction attachment of the dispenser
(see pict. 5 point A).
e) Connect the delivery tube to the other attachment of the dispenser, and the delivery fi tting (see pict. 5 point B).
f) Insert the suction tube with fi lter in the detergent tank.
g) Prime the detergent and proceed to dispense.

2.3 Dispensing the detergent

The detergent dispenser capacity can be adjusted using a screwdriver as shown in pict. 4.
Every 2 cm of product drawn into the tube corresponds to 0.25 cm³ equivalent to 0.3 gr (with a
concentration of 1.2g/cm³). For proper dispensing see paragraph 5.2.
Ø 10
15185
code 15985
pict. 4
INSTALLER SECTION
Make sure that the green product suction tube is inserted on the special fi tting
and that the small fi lter and the ballast are inserted in the rinse aid tank.
C using the appropriate fi xtures.
C
Punto B
min 3
cm
B
A
CONNECTION DIAGRAM
pict. 5
EN
page 27