Table of Contents
Advertisement
Crockery and cutlery not suitable for dishwasher
Not suitable for dishwasher:
• Wooden crockery and cutlery or with wooden parts; water at high temperature causes deformation to wood. Also the
adhesives used are not suitable for treatment in the dishwasher; a consequence could be the handles detachment.
• Crafts, precious vases or decorated glasses.
• Not heat-resistant plastic crockery.
• Copper, brass, pewter or aluminum objects: they may become discolored or opaque.
• The decorations on glass, after a certain number of washes, can lose gloss.
• Fragile glasses or crystal items, if often washed, can become opaque.
We recommend to buy exclusively crockery and cutlery suitable for dishwashing.
After several washes, the glass can become opaque.
It is mandatory to repeat the washing cycle if at the end of the cycle the crockery are not well clean or if there are
washing residues (glasses, cups, bowls, etc. with liquid inside).
4.2 Use of detergent (optional)
The detergent must be of good quality, of NON-FOAMING type, specific for the mechanical washing of dishes.
The use of liquid detergents is recommended.
The dosing has to be done following the recommendations of the detergent manufacturer and in accordance with the water and
dishes characteristics.
The detergent has to be inserted only in the wash tank. 1cm of the detergent drawn into the tube is equal to about 0,15 g. A
correct amount of detergent is very important for a successful wash.
Note: It is forbidden to use detergents with chlorine-based reagents.
4.3 Use of rinse aid
The machine is equipped with a rinse aid dispenser. The machine automatically draws the rinse aid chemical.
The dosing has to be done following the recommendations of the rinse aid manufacturer and in accordance with the water
characteristics.
Note: Too much chemicals produces foam that reduces the effectiveness and lifetime of the washing pumps.
Too much chemicals might leave residuals on the dishes.
4.4 Drain pump system (optional)
To drain completely the wash-tank keep the machine ON, extract the overflow pipe and shut the door. Press the button
D
for at
least one second (see chap.
3. CONTROL PANEL AND RELATIVE
SYMBOLS). The drain pump will automatically drain the
wash-tank.
The indicators F16,
F3
and the scrolling bar
F1
switch ON.
Once the machine is completely drained, the machine will turn off and the indicator
F4
switch ON (stand-by mode).
If you want to refill the machine for a new cycle, wait for 5 seconds before to switch it on by pressing the button A. (see chap.
3.
CONTROL PANEL AND RELATIVE
SYMBOLS).
Opening the door will stop the machine that will re-start when the door is shut.
During the wash-rinse cycle the water in excess is automatically drained.
1
2
3
4
!
EN
Advertisement
Table of Contents
