Updating Blackmagic Converters Setup Utility; Changing Settings Using Switches - Blackmagicdesign ATEM Microphone Converter Installation And Operation Manual

Updating Blackmagic Converters Setup utility

The first step is to download the Blackmagic Converters Setup utility from the Blackmagic
Design support center at
To update the software:
1 Run the Blackmagic Converters Setup installer on your computer and follow the onscreen
instructions.
2 After installation is complete, connect your ATEM Microphone Converter to the computer
via the USB port on the rear panel. You can also connect to your network via Ethernet.
3 Launch Blackmagic Converters Setup and follow any onscreen prompt to update the
internal software. If no prompt appears, the internal software is up to date and there is
nothing further you need to do.

Changing Settings Using Switches

The side panel of the ATEM Microphone Converter features a set of small switches used to
select input type and turn phantom power on or off.
The switch legend printed on the base of the converter indicates which switches are to be
on/off for particular inputs. For example, if you have inputs 1 and 2 set to line and inputs 3 and 4
set to mic with phantom power, the switches will be set as shown in the following illustration.
Inputs 1 and 2 set to line level
NOTE Phantom power is disabled when line level is selected.
www.blackmagicdesign.com/support
1 2 3 4 5 6 7 8
ATEM
Microphone Converter
INPUT 4
PHANTOM PWR PHANTOM PWR
8
OFF ON
7
LINE MIC
INPUT 3
PHANTOM PWR PHANTOM PWR
6
OFF ON
5
LINE MIC
INPUT 2
PHANTOM PWR PHANTOM PWR
4
OFF ON
3
LINE MIC
INPUT 1
PHANTOM PWR PHANTOM PWR
2
OFF ON
1
LINE MIC
Settings 12