Using Blackmagic Converter Utility; Blackmagic Converter Utility; Installing Blackmagic Converter Utility On Mac Os X; Installing Blackmagic Converter Utility On Windows - Blackmagicdesign ATEM Camera Converter Installation And Operation Manual

Hide thumbs Also See for ATEM Camera Converter:

Table of Contents

Using Blackmagic Converter Utility

Blackmagic Converter Utility is used to configure settings and update the internal software in your ATEM

Camera and Studio Converters.

After downloading the Converter Utility software and unzipping the downloaded file, open the resulting

disk image to reveal its contents.

Drag the Blackmagic Converter Utility icon and drop it on to the Applications icon. If Mac OS X presents a

warning message that an older version of Blackmagic Converter Utility exists, choose to replace the older

version. Blackmagic Converter Utility is now installed.

To remove Blackmagic Converter Utility from your Mac, simply drag its icon from the Applications folder to

the Trash and then choose to Empty Trash.

After downloading the Converter Utility software and unzipping the downloaded file, you should see a

Converter Utility folder containing this PDF manual and the Converter Utility installer.

Double-click the installer and follow the onscreen prompts to complete the installation. When the installation

has finished, it will prompt you to restart the computer. The restart will load a USB driver for Converter Utility

so that it can communicate with any ATEM Converter. Click "restart" to complete the installation process.

Once the computer has restarted, Blackmagic Converter Utility will be fully installed and ready to use.

To remove Blackmagic Converter Utility from Windows, go to the Programs and Features control panel,

select Blackmagic Converter Utility and click on Uninstall.

After installing Blackmagic Converter Utility on your computer, connect a USB cable between the computer

and your ATEM Converter. Launch Blackmagic Converter Utility and follow any onscreen prompt to update

the internal software in your ATEM Converter. If no prompt appears, the internal software is up to date and

there is nothing further you need to do.

Table of Contents