Maserati GranTurismo 2024 Owner's Manual page 230

Driving and Driver Assistance Systems
part for 5 seconds to advise the driver to
check the surrounding scenario before
any maneuver.
With transmission in P (Park), N (Neutral)
or D (Drive) mode, the upper right corner
of the screen will show the "X" key:
touch it to go back to the previous
screen of MIA display.
The deactivation of the rear visualization
via "X" soft-key is not possible when the
transmission is in R (Reverse) mode.
Choose the most suitable view for
the situation and the maneuver you
are performing or going to perform,
by touching the soft-key present on
the left of the display: the edges of the
5
pressed button will highlight. The icon
will highlight and the type of selected
view will appear on each image.
In the top view, the vehicle is
represented as it is during the maneuver
(see example in the figure).
To display also the dynamic lines of the
trajectory you are setting, it is necessary
to set this function by accessing the
"Settings" menu on "Vehicle" page of
MIA, at "Camera" item, by using the
dynamic gridlines activation menu.
For further information, see "Functions
of Settings Menu on MIA" in section
"Dashboard Instruments and Controls".
228
The following table shows the
approximate distances for each zone
and color:
Distance to the rear of the
Zone
vehicle
Red 6 - 12 in (15 - 30 cm)
Yellow 12 - 39 in (30 cm - 1 m)
39 - 118 in (1 - 3 m) or
Green
greater
NOTE:
• When a camera fail occurs, the proper
visualization and the top view will be
blackened out.
• In fault conditions, when it is not
possible to change view, the soft-key
on the left of the display will be grayed
out.
• When all the Surround View Camera
system is unavailable, a blue screen
appears to inform the driver of a loss of
communication with the radio.
• To visualize virtual obstacles in 2D and
3D, Virtual Wall function and Park
Assist must be enabled on the MIA
screen (see "Functions of Settings
Menu on MIA" in section "Dashboard
Instruments and Controls") (
Grid lines become gray and virtual
wall detection zone corresponds
approximately to the rear central arc in
Park Assist visualization. Virtual Wall
may not reflect the real position of the
obstacles.
).