Maserati GranTurismo 2024 Owner's Manual page 62

Understanding the Vehicle
2
Rearming the System
If something triggers the security alarm
light, and no quick action is taken to
disarm it, the vehicle security alarm will
turn off the beeper after 29 seconds, and
turn off all of the visual signals after 31
more seconds; the vehicle security alarm
will then rearm itself.
Arming the System
Follow these steps to arm the vehicle
security alarm.
1. Make sure the vehicle ignition device
is in STOP.
2. If any door is open, close it. Perform
one of the following methods to lock the
vehicle:
• Move away from the vehicle with the
key fob above 3.3 ft (1 m) (see chapter
"Passive Entry System" in section
"Before Driving").
• Press the lock button on the key fob
RKE transmitter.
60
In any of these situations, if one or more
windows are open, they will remain
open. To close the windows press again
the lock button and hold it until their
closure.
When arming the alarm system in any
of the described ways, the trunk lid
will remain open if it was left open. In
this condition, it will be necessary to
first close the trunk lid (see chapter
"Trunk Lid Operation" in section
"Before Driving") and repeat the arming
operation, to be able to arm the alarm
system.
Push the button - located on the right
side of the outer edge of the trunk lid
and indicated in the figure - that can be
used to completely close and lock the
trunk lid and arm the alarm system if all
the doors are closed.
For further information, see chapter
"Trunk Lid Operation" in section "Before
Driving".
Each time the vehicle security alarm is
armed, the anti-intrusion and anti-lift
sensors actively monitor the vehicle.
When arming the security alarm, it is
possible to disable these sensors by
pressing the button on the key fob 4
times within 5 seconds from the moment
the system has been armed (meanwhile
the security alarm light flashes).
To disarm the System
Use any of the following steps to disarm
the vehicle security alarm.
• Press the button on key fob.
• Open the door pressing the "Passive
Entry" handle button (see chapter
"Passive Entry System" in section
"Before Driving").
• Press the START/STOP button so as to
release the STOP position.