Speed Limiter - Sl - Maserati GranTurismo 2024 Owner's Manual

Driving and Driver Assistance Systems

Speed Limiter - SL

Using the controls located on the right
side of the steering wheel, the driver can
set a maximum speed limit (SL function)
or maintain a constant cruise control
(CC function) speed without operating
the accelerator pedal. If set, these
two functions SL and CC will exclude
each other according to the driver's
maneuvers.
SL allows the driver to set the maximum
speed limit to be reached by the vehicle.
It is possible to exceed the set maximum
speed by firmly pressing on the
accelerator pedal. After that, if the SL
function is still active, once the driving
5
speed returns under the set value, the SL
function will continue to limit the speed.
Controls
The controls are located on the right side
of the steering wheel.
Control configuration depends on which
driver assist systems are installed to
the vehicle (see "Controls on Steering
Wheel" in section Dashboard and
Instruments and Controls).
There is a specific button to engage and
disengage the SL.
230
Control "pulse activation" buttons have
the following functions:
ON/OFF "pulse activation"
button to engage/disengage
SL system.
Multifunction switch:
SET + / SET − : Increase /
•
Decrease speed, set current
speed
• RES: Resume previously set
speed when system is in
paused status
• CANC: Pause (SL disen-
gaged). The set limit is not
deleted (see paragraph
"Temporary Deactivation" in
this chapter)
Displayed Information
Apart from the pop-up messages at the
center of the display, SL system status
is represented by icons at the top right
of the display, in the dedicated area. See
Instrument cluster overview in section
"Dashboard Instruments and Controls".
Displayed information depends on
system status: ready, set, temporarily
canceled or override.
Activation
Push the ON/OFF button to engage
the system. The white light in upper
right sector of the display will illuminate
and the last set speed is shown.
To disengage the system, push the same
button a second time. The
turn off and a new message pops up for
5 seconds, then the display returns to
the previous setting.
When the SL function is activated, the
system automatically disengage the CC
function if it was active. See chapter
"Cruise Control - CC" in this section for
further information.
light will