Maserati GranTurismo 2024 Owner's Manual page 242

Driving and Driver Assistance Systems
white light will appear on the display
with beside the set speed.
Conditions for Disabling and
Deactivation
Besides the cases specified in the
previous paragraph, the following
conditions will disable the system:
• "CORSA" drive mode is set.
• The driver disabled the ESC using
the ESC Off soft-key on the Comfort
Display.
The system is deactivated and set speed
is deleted from system memory, if the
ACC ON/OFF button is pressed or if
ignition device is turned to STOP.
5
Resuming Speed
If a speed setting is stored in system
memory, press the button (RES) and take
foot off the accelerator pedal. The last
set speed will be displayed.
WARNING!
The resume function should be used
only when road and traffic conditions
allow it. Resuming a too high or too
low speed for current traffic and road
conditions could cause a harsh vehicle
acceleration or deceleration which could
increase the risk of collisions and death
or serious injury.
240
Setting the Time Gap
The specified time gap has four different
settings, identified by 4 horizontal bars
that represent 4 different time gaps:
• Maximum (longest) time: 4 bars (default
time).
• Long time: 3 bars.
• Medium time: 2 bars.
• Short time: 1 bar.
Based on both time gap, selected by the
driver, and the actual vehicle speed, ACC
calculates the distance to keep from the
vehicle ahead.
If another information covering ADAS
visualization in the main area (textual
pop ups, NAVI information, phone call,
etc...) are displayed, the ACC time gap
symbol shall be displayed in the top right
corner for the time the ADAS in the main
area is covered (see detail in picture).
If system does not detect the presence
of any vehicles ahead, only the bars
referred to set time gap will be
displayed.
When system detects the presence of a
vehicle ahead, it is displayed in front of
the bars (see example in the figure).
To increase or decrease the number of
bars, corresponding to the time gap from
vehicle ahead, press and release the
related setting "pulse activation" button.
Each press and release of the button
changes the time gap starting from
4 bars (default time) and moving in a