Step 5: Front Left Side; Step 6: Front; Step 7: Front Right Side; Step 8: Inside The Vehicle - PREVOST H3-45 2023 Operator's Manual

Table of Contents

Advertisement

wheels or rims; valve caps in place and no
objects stuck between the wheels.
Check
that
l
compartment doors are properly latched and
locked.
Check optional auxiliary coolant heater for
l
fuel leaks.

STEP 5: FRONT LEFT SIDE

Check condition of wheel rim. Especially
l
look for cracks, missing nuts, bent or broken
studs.
Check condition of tire: properly inflated, no
l
serious cuts, bulges, tread wear or any signs
of misalignment; valve stem not touching
wheel or rim; valve cap in place.
Check windshield washer reservoir fluid
l
level and add as necessary.
If
equipped,
check
l
reservoir fluid level and add as necessary
Drain accessory air tank by opening drain
l
cock. Close drain cock when completed.

STEP 6: FRONT

Check windshield for damage and clean if
l
dirty.
Check windshield wiper arms for proper
l
spring tension.
Check wiper blades for any damage, "dead"
l
rubber and attachment to arm.
Check clearance and identification lights,
l
they should be clean.
Check high and low beams, they should be
l
clean. If equipped, check fog lights.
Check left and right directional signals, they
l
should be clean.
baggage
and
service
headlights
washer
PA-1652 Operator's Manual H3-45 Coach
Care and Maintenance 8-27
Check to see that there is no mud, snow, ice
l
build-up or other obstruction in front of the
ACB radar sensor if applicable.

STEP 7: FRONT RIGHT SIDE

Check condition of wheel rim. Especially
l
look for cracks, missing nuts, bent or broken
studs.
Check condition of tire: properly inflated, no
l
serious cuts, bulges, tread wear or any signs
of misalignment; valve stem not touching
wheel or rim; valve cap in place.

STEP 8: INSIDE THE VEHICLE

Check for proper operation of the entrance
l
door.
Check steps; clean them if there is any
l
substance that makes them slippery, which
makes coach entry/exit hazardous.
Adjust and clean mirrors for adequate rear
l
view vision.
Verify proper operation of windshield wiper/
l
washer.
Check for fire extinguishers to make sure
l
they are ready for operation.
Check that emergency exit windows and roof
l
escape hatches can be opened then close
all windows and hatches securely.

WITH ENGINE RUNNING

Start engine and check for proper operation
l
of all gauges. Perform a telltale light test (see
Cluster self test in
(DID) Menus
). Indicator lights and buzzers
should all be OFF before driving.
Using the message center display, perform a
l
system diagnostic to check if error codes
and anomalies were recorded in the vehicle
electronic modules.
Driver Information Display

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents