Drying; Descale - Miele DGC 7150 Operating And Installation Instructions

Drying

You can use this maintenance
programme to dry any residual moisture
in the oven compartment, including in
inaccessible areas, and protect the
oven against corrosion.
The maintenance programme
Drying
comprises up to 3 phases: residual
water evaporation in the empty oven
compartment, drying by heating the
compartment and rapid cool-down with
the door slightly open.

Risk of infection due to
contaminated water in the water
container.
Germs can form in the water
container if you do not run the
maintenance programme. This
Drying
contaminated water could be
evaporated onto the food during the
next cooking process.
Run the maintenance
Drying
programme to ensure that all residual
water fully evaporates.
 Select
Further  |
Drying .
 Follow the instructions on the display.
 Remove the water and condensate
from the oven compartment and drip
channel using a sponge or absorbent
cloth.
 Switch the combination steam oven
off once the Drying
programme has finished.
Maintenance |
maintenance
Cleaning and care

Descale

The frequency of descaling will depend
on the water hardness level in your area.
The descaling process can be run at
any time.
However, to ensure that the oven
functions correctly, you will be
automatically prompted to run the
descaling process for the steam
injection system after a certain number
of cooking processes.
The oven will count down in the display
the last 10 cooking processes that can
be run before it needs to be descaled.
You will then not be able to run any
operating modes, automatic
programmes and maintenance
programmes using moisture assistance.
These operating modes can only be
used again after you have carried out a
descaling process. All other operating
modes, automatic programmes and
maintenance programmes without
moisture assistance can still be used.
Descaling process sequence
Once the descaling process has been
started, it must be completed through
to the end. It cannot be cancelled.
Descaling takes approx. 140 minutes
and consists of several steps:
1. Preparing the descaling process
2. Drawing in the descaling agent
3. Activation phase
4. Rinse 1
5. Rinse 2
6. Rinse 3
7. Evaporating the residual water and
drying the oven compartment
85