Installing The Combination Steam Oven - Miele DGC 7150 Operating And Installation Instructions

Installing the combination
steam oven
For safety reasons, the combination
steam oven may only be used when
it has been fully installed.
The combination steam oven
requires a sufficient supply of cool air
for efficient operation. The required
supply of cool air must not be
excessively heated by other heat
sources (e.g. solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the interim shelf that
the combination steam oven sits on
does not touch the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
 Connect the combination steam oven
to the electrical supply.
Carrying the combination steam
oven by the door handle could
damage the door.
Use the recessed grips on the side of
the housing to carry the appliance.
It is a good idea to remove the door
(see "Cleaning and care – Removing
the door") and the accessories before
installing the appliance. The
combination steam oven is then easier
to push into the housing unit and you
do not run the risk of lifting it by the
door handle.
 Push the combination steam oven
into the housing unit and align it.
 Open the door, if you have not
removed it.
 Use the screws supplied to secure
the combination steam oven to the
side walls of the housing unit.
 Refit the door if necessary (see
"Cleaning and care – Fitting the
door").
Installation
105