Kimball Office Footprint Bevel Profile Highback Organizer Assembly Instructions

Footprint
®
Bevel Pro le Highback Organizer

Tools Required

Drill
#2 Phillips head bit

Package Contents

Overhead storage unit
Two end panels
(non-handed)
Tackboard envelope

Shipped Separately

Tackboard

Description

These instructions provide basic information to assemble a
Footprint bevel pro le highback organizer and attach it to a
Footprint freestanding modular worksurface with metal
support or storage. Highback organizer must be the same
width as the rectangular freestanding unit. Highback organizer
is shipped ready to assemble (Figure A).
Note: One person can perform all operations, although two may
be required to handle larger, heavier units.

Installation

1. Close and lock receding doors in overhead storage unit to
prevent them from sliding open during installation.
Note: Locks are shipped separately from the unit. It is
recommended that you install the lock prior to installation.
2. Turn overhead storage unit upside down with the door
facing you.
3. Remove inset pieces from end support panels. With the
smooth side of the left end support panels facing outward,
secure the panel to the underside of the storage unit using
three #10 x 1/2 " screws in pre-drilled hold locations. Repeat
for the right end support panel (Figure B).
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball O ce Customer Service.
Part No. 2112655 Revision E
Level
Tape Measure
Four #8 x 3/4" Phillips pan
head drill screws
18 #10 x 1/2 " hex washer
head drill screws
Lock(s)
Figure A
Overhead
Storage
Figure B
Removable
Inset Piece
End support
panel—
Smooth s id e
faces out w ar d
Assembly Instructions
Page 1 of 3
Tackboard
Envelope
End support panels